User Guide: OpenLRS

dRonin supports directly detecting packets from OpenLRS when using a board that has an RFM22B module (e.g. Revolution, Sparky2 or BrushedSparky).

Binding

https://vimeo.com/124850842

Note: you should make sure to bind your OpenLRS with telemetry turned off. I have tried with FrSky SmartPort and had success but this is less tested.

1. in the HwSparky2 settings set the Radio field to "OpenLRS"
2. Save settings
3. If you have previously bound to OpenLRS and want to bind again, go to the UAVObjectBrowser and erase OpenLRS
4. Reboot board
5. You should see the RF LED blinking at 5 Hz
6. Put the OpenLRS TX module in binding mode
7. You should see the RF LED stop blinking Note: OpenLRS TX module may or may not acknowledge bind. If the Transmitter module does not recognize binding, power cycle the transmitter.

At this point you should be bound and can perform input configuration like normal.