Spray Servo

Upload the code from the spray-servo.ino file to an ESP-32 board and enjoy !

The code includes :

• A simple webpage to control the servo
• Soft Access point to access the webpage
• The servo control

Default access point credentials

• ssid: spray-servo
• password: 12345678

3D Printed Parts

Inside the STL Files folder you will find all the necessary parts to print. Those parts are designed by Alikens and this is the original parts page.

Connections

• Connect the Signal Yellow/White cable of the servo on the GPIO 13 of the ESP-32 board.
• Connect the Power Red cable of the servo with the one from the battery and the VIN Pin of the ESP-32 board which will also be powered by the battery.
• Connect the Ground Black cable of the servo with the one from the battery and the GND Pin of the ESP-32 board.