1.6

• Introduced new remote API to allow calling almost ALL NodeManager's and its sensors' functions remotely
• Reporting interval configuration is now indipendent from the sleep cycle
• Reporting interval can be customized per-sensor
• All intervals (measure/battery reports) are now time-based
• Added support for BMP280 temperature and pressure sensor
• Added support for RS485 serial transport
• Added support for TSL2561 light sensor
• Added support for DHT21 temperature/humidity sensor
• Added support for AM2320 temperature/humidity sensor
• Added support for PT100 high temperature sensor
• Added support for MH-Z19 CO2 sensor
• Added support for analog rain and soil moisture sensors
• Added support for generic dimmer sensor (PWM output)
• Added support for power and water meter pulse sensors
• Radio signal level (RSSI) is now reported automatically like the battery level
• SensorRainGauge now supports sleep mode
• SensorSwitch now supports awake mode
• SensorLatchingRealy now handles automatically both on and off commands
• SensorMQ now depends on its own module
• Added safeguard (automatic off) to SensorDigitalOutput
• Any sensor can now access all NodeManager's functions
• DHT sensor now using MySensors' DHT library

1.5.1

• Optimized memory utilization by saving up to 20% on a pro mini board

1.5

• Added support for ACS712 current sensor
• Added support for HC-SR04 distance sensor
• Added support for BMP085/BMP180 temperature and pressure sensor
• Added support for Sonoff smart switch
• Added support for Rain Gauge sensor
• Added support for MCP9808 temperature sensor
• Added forecast output to all Bosch sensors
• Added I2C address auto-discovery for all Bosch sensors
• Added support for running as a gateway
• Added option to retrieve the latest value of a sensor from outside NodeManager
• Remote reboot now does not need a reboot pin configured
• A heartbeat is now sent also when waking up from a wait cycle
• When waking up for an interrupt, only the code of the sensor expecting that interrupt is executed
• Added capability to retrieve the time from the controller
• Optimized battery life for DS18B20 sensors
• SLEEP_MANAGER has been deprecated (now always enabled) and setMode() replaces setSleepMode()
• New mode ALWAYS_ON to let the node staying awake and executing each sensors' loop
• ESP8266WiFi.h has to be included in the main sketch if MY_GATEWAY_ESP8266 is defined
• Added receiveTime() wrapper in the main sketch
• Fixed the logic for output sensors
• Added common gateway settings in config.h

1.4

• Added support for ML8511 UV intensity sensor
• Added support for MQ air quality sensor
• Added ability to manually assign a child id to a sensor
• Ensured compatibility for non-sleeping nodes
• Ability to control if waking up from an interrupt counts for a battery level report
• When power pins are set the sensor is powered on just after
• Service messages are disabled by default
• Bug fixes

1.3

• Added support for BME280 temperature/humudity/pressure sensor
• Added option to measure battery level via a pin in addition to internal Vcc
• Added example sketches to the documentation
• Fixed a few bugs

1.2

• Added out-of-the-box support for BH1750 light sensor
• Added out-of-the-box support for HTU21D temperature and humidity sensor
• Added out-of-the-box support for MLX90614 contactless temperature sensor
• Added a few examples to the documentation
• Fixed a few bugs

1.1

• Added ability to sleep between send() so to save additional battery
• Bug fixes

1.0

Initial release