A remote occupancy sensor for the single bathroom stall in a large office.
This solution leverages a battery powered Espruino MDBT42Q and a RaspberryPi 3 loaded with EspruinoHub to broadcast BLE sensor data via MQTT and serve a static dashboard page.
Follow the installation instructions for EspruinoHub on a Raspberry Pi 3.
Update config.json with the MDBT42Q address and put it in ~/pi/EspruinoHub.
Open the Espruino IDE at http://RASPBERRY_PI_IP:1888/ide. Load MDBT42Q.js to the MDBT42Q and run save().
Navigate to http://RASPBERRY_PI_IP:1888/mqtt to verify MQTT broadcast.
Navigate to http://RASPBERRY_PI_IP:1888/bathroom to view the bathroom status.
Adafruit 500 mAh LiPo Battery Adafruit LiPo Charger Sparkfun Tilt Sensor Slide Switch
An excellent bridging solution to serve BLE advertising data via MQTT. This lives on the Raspberry Pi 3 and serves the following topics:
/ble/advertise/stall-monitor-men/l // Lock Status
/ble/advertise/stall-monitor-men/d // Previous State Duration (sec)
/ble/advertise/stall-monitor-men/battery // Battery Status (Percentage based on max voltage of 3.3V and min voltage of 2.5V)
/ble/advertise/stall-monitor-men/rssi // RSSI
The BLE sensor itself runs Javascript, with a number of libraries built in for GPIO and BLE control. See the sensor code in MDBT42Q.js.
The code uses setWatch and NRF.setLowPowerConnection to maximize battery life.
The case was designed in AutoDesk Fusion 360, and printed on a MakerBot Replicator 2. Design files can be found in /case