Read the documentation in qemu-doc.html or on http://wiki.qemu-project.org
- QEMU team
========
This is a fork of gnuarmeclipse's QEMU repository. Their repository adds some cpu/board definitions for common Kinetis chips, though it does not yet emulate any peripherals as of yet - it only sets up a cortex-m0+ cpu with a specific amount of ram/flash.
This fork aims to add some basic support for a handful of peripherals in order to achieve automated unit testing of a project built using the FRDM-KL03Z board.
Currently supported features (for FRDM-KL03Z - no other MCUs have been modified; see kinetis_mcus.c to add support for your own. 20~50 LOC per MCU):
- SRAM_L (and SRAM_U)
- Bit Manipulation Engine
- Low-Power UART (LPUART) (partial)
- Low-Power Timer (LPTMR) (fully functional except for Pulse Counter mode)
- Multi-purpose Clock Generator Lite (MCGLite) (though clock settings are not propagated to the core / peripherals)
- System Integration Module (SIM) (less the watchdog timer)
- System Mode Controller (SMC) (Though stop modes cannot be entered)
- GPIO/PORT (including NMI pin)
The easy way to build this is as follows (run in a shell):
export CFLAGS="-Wno-error"
./configure --target-list="gnuarmeclipse-softmmu" --prefix=/usr/local
make all
sudo make installNote: if you run into build errors during make all inside config-host.h and are on a system that uses unix line-endings, try running dos2unix config-host.mak and then running make again.