Provides weather information based on selected location
Arduino Weather Station is a 3D Printed homemade project, that has requires only a few components to build it
- Wemos D1 Mini
- ST7735 1.8" Color TFT Display.
- female to female jumper wires
- (and a 3D Printer of course)
No soldering required.
This project body/case was printed using PLA (1.75mm) the .STL files are available on Thingiverse
Pin connections between our device and the display.
| Wemos D1 Mini | TFT 1.8" Display |
|---|---|
| 5V | VCC |
| GND | GND |
| D8 | CS |
| D4 | RESET |
| D3 | A0 |
| D7 | SDA |
| D5 | SCK |
| LED | 3V3 |
OR nodemcu esp8266 (not tested yet)
| nodemcu ESP8266 | TFT 1.8" Display |
|---|---|
| 5V | VCC |
| GND | GND |
| D8 | CS |
| D4 | RESET |
| D3 | A0 |
| D2 | SDA |
| D1 | SCK |
| LED | 3V3 |
Copyright 2019
Licensed under the Apache License, Version 2.0 (the "License");
you may not use this file except in compliance with the License.
You may obtain a copy of the License at
http://www.apache.org/licenses/LICENSE-2.0
Unless required by applicable law or agreed to in writing, software
distributed under the License is distributed on an "AS IS" BASIS,
WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
See the License for the specific language governing permissions and
limitations under the License.