leko pona

Related repos

• ZMK config (layout based on colemak-dh)
• Ergogen config used to generate the pcb

Parts list

• nice!nano x2
• 12 pin socket strips x4
• JST-PH battery connectors x2
• PCM12 power switch x2
• 3.7V 130mAh battery x2
• choc switches x36
• choc keycaps x36
• choc hotswap sockets x36 (optional)
• rubber feet (optional)

Notes about assembly

• Solder pads for the reversible footprint should be soldered on the underside of the board if you want the back of the nice!nano facing up (like in the picture)
• The battery connector is slightly asymmetrical on the two halves, it should be clear from the outline on the silkscreen which way to put it
• If your batteries are small enough you can tuck them under the controllers
• You can use a permanent marker to get a clean look on the edges of the pcbs

LEGO tenting set

Instructions