Toybox Turbos Hangs on Startup

[Enverex]

Works fine without ESync, but never finishes loading on startup if ESync is enabled (the loading spinner just goes on forever).

[zfigura]

As usual, please attach a log with +esync,+server,+seh,+pid,+timestamp.

[Enverex]

Log of +esync,+server,+seh,+pid,+timestamp attached.
I killed it after a minute or two as it doesn't progress past that point.

trace.log.gz

[zfigura]

Hmm, this is nontrivial to trace down. The application is spinning and doing d3d work up until the point where it's killed. If you can attach a log with the same channels and esync disabled, that may be helpful.

[Enverex]

As requested. I left it on the menu for a few seconds (which is the part of the load process after the bit that gets stuck with ESync enabled).
trace2.log.gz