Multiscale Structural Mechanics
Cross-Section analysis for L-shaped configuration #15
-
|
Hi Team, The crosssection, material and baseline .xml files are also attached for reference. When i run the problem, the Gmsh file opens without any output and i get the following error message in command line. Is there any way to debug this error. Thanks for the help. Regards, |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments
-
|
You only need to use one side of the geometry as the "baseline". For example, p6->p7->p8->p1. The thickness of the part (p1-p2) is controlled by the plies of the layup. In addition, when defining the "arc", it should be "center" instead of "centre". |
Beta Was this translation helpful? Give feedback.
-
|
Thanks for the answer. I am able to run the file after these modifications. |
Beta Was this translation helpful? Give feedback.
You only need to use one side of the geometry as the "baseline". For example, p6->p7->p8->p1. The thickness of the part (p1-p2) is controlled by the plies of the layup.
In addition, when defining the "arc", it should be "center" instead of "centre".