Trouble Programming

[rainyvalley]

I apologize for reaching out, but I have been having a large amount of issues flashing my own device's. I also have a unit purchased from tindie which cannot be recognized by my cc debugger as well (Both stay on red). I can see the cc debugger in device manager under "cebel controlled device's" so I am assuming the drivers are installed properly.

Finally, I am following the below diagram to try and wire (without the resistors) where 2.2 to 3, 2.1 to 4, 3.3 to 9, GND to 1, and RST to 7.

I'm a bit at my witt's end as to what's going wrong so any assistance would be greatly appreciated. I tried to do my own research before coming here.

[yayitazale]

I have programmed my own devices without any problems. The only thing to keep in mind is that you have to put the battery in the sensor to program it.

[yayitazale]

I have a lot of issues programming them. Some of the sensors stay on red whatever I do so I assume I have fried them when soldering. Then I have a bunch of them that I can program but verification fails and they don't pair anyway...

Is quite exasperating :(