Skip to content

Latest commit

 

History

History
16 lines (12 loc) · 946 Bytes

ar150-flash-process.md

File metadata and controls

16 lines (12 loc) · 946 Bytes
Raw

Flashing a Gl-AR150-based Mesh Observer

  1. Connect an Ethernet cable between the AR150's WAN port and your computer
  2. Configure your Ethernet interface to use the IP 192.168.1.2
  3. Hold the reset button down on the AR150
  4. Connect power to the AR150 while still holding the reset button
  5. Let go of the reset button on the 6th blink of the red light (the centre green light should illuminate as the red one does)

After releasing the reset button, the red light should blink rapidly for about a second. If not, and instead both green LEDs are lit, then you must have released the reset button too early or too late. Disconnect power and repeat steps 3-5 again.

  1. Open http://192.168.1.1 in your browser
  2. Click 'Choose file' and select the firmware file
  3. Click 'Update firmware'
  4. Wait for the upload to complete and the router to reboot automatically

The firmware should have been successfully flashed