diff --git a/docs/buildguide_wabble-60_rev2024.2.md b/docs/buildguide_wabble-60_rev2024.2.md
index 5797b54..f58d2f4 100644
--- a/docs/buildguide_wabble-60_rev2024.2.md
+++ b/docs/buildguide_wabble-60_rev2024.2.md
@@ -93,9 +93,9 @@ It may also be useful to have:
1. Solder a PH2.0 connector to the LiPo battery.
- 
+ 
- 
+ 
Alternatively, the battery can be soldered directly to the WABBLE-60 PCB.
@@ -108,20 +108,20 @@ It may also be useful to have:
To do this, gather the WeAct BLE core board, round-pin male headers, and a spare breadboard.
- 
+ 
Cut the header pins down to an appropriate number.
- 
+ 
Solder the round-pin headers to the core board:
- 
+ 
The pins can be cut, and the solder joints reflowed,
which hopefully looks a bit neater than leaving the pins untrimmed:
- 
+ 
3. Solder the USB connector.
@@ -129,29 +129,29 @@ It may also be useful to have:
It may be helpful to [review a video on soldering a USB-C port](https://www.youtube.com/watch?v=e6TMxctCcxU).
- 
+ 
- 
+ 
4. Solder the LiPo charging circuitry.
Solder the TP4054 to U2:
- 
+ 
- 
+ 
Solder 2x 1N5819 to D1, D2;
a 22k resistor to R3;
a 10k resistor to R4;
and the R_PROG resistor to R5:
- 
+ 
Solder the BSS138 to Q1:
- 
- 
+ 
+ 
5. Solder the switch diodes.
@@ -164,9 +164,9 @@ It may also be useful to have:
It may be too tedious to try to solder all 60 at once.
One approach is to solder just the "inner" diodes at once, then the "outer" diodes.
- 
+ 
- 
+ 
6. Solder the tall through-hole components.
@@ -185,8 +185,8 @@ It may also be useful to have:
For the PH2.0 headers, orientation needs to match the silkscreen markings.
- 
- 
+ 
+ 
7. Check the USB connector and LiPo charging.
@@ -202,8 +202,8 @@ It may also be useful to have:
or that the 'CHARGE' LED is bright if the LiPo battery is not fully charged
when a USB cable is connected.
- 
- 
+ 
+ 
8. Solder the switches.