Batch case configuration

[gocfd]

Hello,

can you please help me to correctly configure batch case? I would like to change mass flow as an input parameter and monitor static pressure as an output parameter.

Thank you.

[kdg5424]

Hello @gocfd. This is Donggyu from NEXTFOAM.

Could you check the parameter is written in Capital language?
It should be written in Captial langauge.
And you should make a .csv file for the parameter. It should be like the below picture.

Best regards

Donggyu kim

[gocfd]

[kdg5424]

Hello Gasper. I was mistaken. I recommend you to use Capital Language for the parameter.

Thanks

[gocfd]

Hello, I did exactly as you described on Github. However, when I try to import .csv file to Batch case nothing happens. The file is not shown in the table. [image: image.png] Best regards, V V pet., 16. avg. 2024 ob 09:03 je oseba kdg5424 ***@***.***> napisala:

…

Hello Gasper. I was mistaken. I recommend you to use *Capital Language* for the parameter. Thanks — Reply to this email directly, view it on GitHub <#111 (reply in thread)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AWB3IJETMZN6IKPOKSV3AETZRWP4RAVCNFSM6AAAAABMQKHQP6VHI2DSMVQWIX3LMV43URDJONRXK43TNFXW4Q3PNVWWK3TUHMYTAMZVGU2DKMA> . You are receiving this because you were mentioned.Message ID: ***@***.***>

[kdg5424]

Hello.
I can't see the picture what you uploaded.
Could you upload again?

Best regards

[kdg5424]

Hello.

I still can't see the picture.
Anyway could you try to run BARAM again with adminstrator mode?

Regards

[gocfd]

Hello,

I did run Baram as administrator.

Best regards

[kdg5424]

Hello. Then, is everything fine with your case?

Regards.

[jiban]

Hi @gocfd ,
Could you share the CSV file you used? (i.e. batch_case_test.csv file )

[gocfd]

Hello,

batch_case_test.csv

[jiban]

Dear @gocfd,
The separator should be ,(comma) rather than ;(semicolon) as CSV stands for Comma Separated Values.
Please refer to following files. (Right one is correct one)

[gocfd]

Hello,

great, now it works! However, when I want to click Start Calculation pop up window appears:

Best regards

[jiban]

Only scheduled cases will join the calculation.
Select case(s) in the list by mouse click (and optionally CTRL or SHIFT key) as you usually do in Windows File Explorer, and click-click mouse button.
This will show context menu like following.

Once scheduled, you can see the check mark in Calc. column.

Only those checked cases will be calculated in order if you click Start Calculation button.

[gocfd]

Great, now it works. Many thanks!

Best regards,