README

[Global]
timeout = 0
# bus timeout value in seconds 
long-push-threshold = 30
# amount of time a button has to be pressed unitl a long push is recognized (1/10 s) 
brownout-threshold = 0
# supply voltage below which the outputs will be switched off (in mV)
description = none
# max. 16 ASCII characters

[Input0]
short-on = 4
short-off = 4
# toggle output 4 if button at input 0 is pressed for a short time 
long-on = 
long-off = 0,1,2,3,4
# switch off outputs 0,1,2,3 and 4 if button at input 0 is pressed for a long time
switch-type = push-button
# switch-type can either bei push-botton or toggle-switch. A state change of a toggle switch is interpreted as a short button press. Of course there is no long button press then..
pattern-saving-shortpush = off
pattern-saving-longpush = off

[Input1]
short-on = 0,1,2
short-off = 0,1,2
long-on = 
long-off = 
switch-type = push-button
pattern-saving-shortpush = on
# if pattern saving is on, 
pattern-saving-longpush = off

[Output0]
input-controlled = never
# can either be always, timeout-only or never
timer-controlled = never
# can either be always, timeout-only or never
timeout-value = 0
# time after which the output will be turned off (seconds). only works if value is greater 0 and
# timer-controlled is not set to never
default-state = off
# state the output assumes after system startup

[Output1]
input-controlled = always
timer-controlled = never
timeout-value = 0
default-state = off