You can check if your accelerometer is working correctly. In the configurator go in the sensors tab and look at the accelerometer curves. When your FC is flat the green and blue lines should be near 0. When on the side the green and red lines should be near 0. And when on the front the blue and red lines should be 0.

[Sedgee]

You can check if your accelerometer is working correctly. In the configurator go in the sensors tab and look at the accelerometer curves. When your FC is flat the green and blue lines should be near 0. When on the side the green and red lines should be near 0. And when on the front the blue and red lines should be 0.

Originally posted by @shellixyz in #2781 (comment)

[Sedgee]

Hi, When I get the sensors working as described above the graphic in the setup page shows yaw is out by 90 deg. When I correct this in Configuration/Board Alignment/Yaw 90 deg, the graphic in setup is correct but the sensor shows the red and green together when on the front. Either way when calibrating the Accelerometer the graphic for nose down is ticked when craft/board is on it's side. The arrow on the board is pointing forward as it should.
Board is a GepRC Span F722 HD BT loaded with INAV 2.6.
Any help appreciated.