eGPU works!! (No hotplug)

[sk0n3]

I got the egpu working consistently by combining
NUC 8IxBEx's Thunderbolt SSDT: (since thunderbolt drivers are the same)
SSDT-TYPC-NUC8-PC.aml

In SSDT-NUC10.aml file, I took everything after Scope (PSXS) all the way until Scope (LPCB) and then replaced it with the content of SSDT-TYPC-NUC8-PC.aml (After Scope (_SB.PCI0.RP05.PXSX)). I don't know enough about this stuff so I didn't bother cleaning up the file after combining but maybe someone can do it?

[sk0n3]

[mrasong]

Did you try to do work like below?

1. Add SSDT-TYPC-NUC8-BC.aml to /EFI/OC/ACPI fold.
2. Add SSDT-TYPC-NUC8-BC.aml to NUC10's EFI config.list

[mrasong]

DO NOT change SSDT-NUC10.aml and add extra SSDT-TYPC-NUC8-BC.aml

[sk0n3]

No not like that. I used Maciasl to replace thunderbolt ssdt

[mrasong]

Did this change affect other features of typec? eg. Typec to HDMI / DP? Typec hub?

[mrasong]

I can't test this cause I did not have an eGPU device.

[sk0n3]

Nothing that I notice as of right now, secondary type c display works, and my thunderbolt storage is also recognized too.

[sk0n3]

I have an owc miniStack STX thunderbolt dock and every port works just fine

[sk0n3]

I removed AGPM_NO.kext and substituted an appropriate power management kext using AGPMInjector

[lw8610]

Would it be possible for you to provide me the SSDT-NUC10.aml you created to get an eGPU work with NUC10? I would like to try it out.