Error not with GO-E Charger #16717

[BeginnerEVCC]

Following error pops up in EVCC. The function itself seems to work. Is anyone able to assist? Do NOT Close this case unless you have some proper advise for someone who is not a pro, thanks!

Garage: charger status: Get "http://192.XXX.XXX.XX/api/status?filter=alw,car,eto,nrg,wh,trx,cards\": dial tcp 192.XXX.XXX.XX:80: connect: no route to host

[mfuchs1984]

Config file (without passwords, Sponsortoken, etc.)? Exact model and firmware version of your go-e charger? Http API enabled in the charger settings?

[BeginnerEVCC]

Dear mfuchs, thanks for your guidance. API (Access on local http-api v2 granted) is on. All other configs are off. I´m not sure if any of the other api application needs to be activated. I´m using HA to work with EVCC. The GO-e is an GO-E Charger Gemini Flex 11 kW on V 56.8.

[mfuchs1984]

Have you double checked the IP address? Evcc configuration file is still missing.

[BeginnerEVCC]

IP is correctly addressed within the config. The error shows up occasionally, not permanent. The loading via PV works well.

[mfuchs1984]

There are some guys claiming the go-e 56.8 has connections issues here
https://www.photovoltaikforum.com/thread/231716-go-e-gemini-charger-probleme-mit-56-8-software/

[BeginnerEVCC]

I thought so to. It is a mesh repeater, from from FritzBox. The strength is pretty well (about 80% at the wallbox). I saw those issues to. Currently I believe it will all work out. Just want to avoid a damage at the GO-e charges which causes a breakage. Thanks again for looking in to this matter mfuchs1984!

[mfuchs1984]

I think you should try to downgrade the software of the go-e, see link above.

[BeginnerEVCC]

Thanks, I just go on Beta trial. If this is not helping i will downgrade as described with the post you forwarded.

[thebrainkafka]

No issues using 56.8 on Gemini at my end.

When setting up my EVCC environment i also used a fritz mesh repeater resulting in bad connectivity with the go-e.
Switching to a simple low budget repeater did the trick. Check also the go-e homepage for a low budget repeater advice.

[BeginnerEVCC]

After setting the IP setting back to automatically I was able to return to 56.8. System works stable now. The Fritz Mesh Repeater is not the issue. It mus be the current firmware and even the BETA versions are affected to. The big trouble is really to the the charge back online (not only via the go-e hotspot accessible). I hope that they will get this fixed. An upgrade however will not be for now. Thanks for the feedback shared.