- Plug in stepper motors for X, Y, Z, and E in positions X, Y, Z, and E0
- Plug Hot End thermistor to thermistor T0 (PF0)
- Plug Hot End heater in to extruder heater HEAT-0 (PE5)
- Plug Hot End Fan in to FAN-1 (PH5)
- Plug Part Cooling Fan in to FAN-2 (PH3)
- Plug Bed Thermistor in to thermistor T2 (PF2)
- Connect Bed Heater to Bed Output (PG5)
- Connect X end stop to X-MIN (PB6)
- Y Endstop is not used.
- Connect inductive probe to Probe input (PB4), on pins +, -, and 's' on the drawing. Pin 1 (T) is unused.
- Wire +V and -V from DC power supply to both Power Input and Bed Power Input.
- Connect USB Cable, but do not connect it yet to your Raspberry Pi
