| layout | title |
|---|---|
documentation |
ZW500D - ZWave |
{% include base.html %}
This describes the Z-Wave device ZW500D, manufactured by Wenzhou MTLC Electric Appliances Co.,Ltd. with the thing type UID of enerwave_zw500d_00_000.
The ZW500D supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.
No device information is provided in the database. Consider updating the database to improve the documentation.
The following table summarises the channels available for the ZW500D -:
| Channel | Channel Id | Category | Item Type |
|---|---|---|---|
| Dimmer | switch_dimmer | DimmableLight | Dimmer |
The brightness channel allows to control the brightness of a light. It is also possible to switch the light on and off.
The switch_dimmer channel supports the Dimmer item and is in the DimmableLight category.
The following table provides a summary of the 2 configuration parameters available in the ZW500D. Detailed information on each parameter can be found in the sections below.
| Param | Name | Description |
|---|---|---|
| 1 | configure LED light state | configure LED light state |
| 2 | Reverse installed direction | Control if switch up is on or off |
| Switch All Mode | Set the mode for the switch when receiving SWITCH ALL commands |
configure LED light state 0 = LED off with load on
1 = LED on with load on The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | LED off with load on |
| 1 | LED on with load on |
The manufacturer defined default value is 0 (LED off with load on).
This parameter has the configuration ID config_1_1 and is of type INTEGER.
Control if switch up is on or off 0 = normal install, up is on
1 = invert switch The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | normal install - up is on |
| 1 | invert switch |
The manufacturer defined default value is 0 (normal install - up is on).
This parameter has the configuration ID config_2_1 and is of type INTEGER.
Set the mode for the switch when receiving SWITCH ALL commands.
The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | Exclude from All On and All Off groups |
| 1 | Include in All On group |
| 2 | Include in All Off group |
| 255 | Include in All On and All Off groups |
This parameter has the configuration ID switchall_mode and is of type INTEGER.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The ZW500D supports 1 association group.
Association group 1 supports 5 nodes.
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_NO_OPERATION_V1 | |
| COMMAND_CLASS_BASIC_V1 | |
| COMMAND_CLASS_SWITCH_MULTILEVEL_V2 | Linked to BASIC |
| COMMAND_CLASS_SWITCH_ALL_V1 | |
| COMMAND_CLASS_CONFIGURATION_V1 | |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1 | |
| COMMAND_CLASS_ASSOCIATION_V1 | |
| COMMAND_CLASS_VERSION_V1 |
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.