Review of "replace_physical_drillings_with_drilling_axes"

[ancelin-charpentier]

Hi, I tried this command and it works quite well however there are some issues that are coming with it.
I exported an IFC in viewer mode and run this command to it.

• 1st issue is you need to run "Ctrl+F" (Facet correction) prior to run the API and it does not seems to be doable straight from the API.
• Sometimes the drilling gets created within the maintained hole (Case 1), sometimes the drilling is created and the "physical" drilling is removed (Case 2). Is there any way to set a consistent rule there?
  
• Would it possible to get the drilling length to be set to the rough volume of part it is in?