Econotag Configuration
The Econotag is an open hardware development kit based on the FreeScale MC13224 ARM7 802.15.4 System on Chip. Amongst other things, it provides 96KB of RAM and 128KB of flash and a variety of I/O, which makes it a great platform to develop a standalone Border Router. In order to connect the Econotag to the Ethernet network without relying on an additional host, we need to add an Ethernet controller. We choose to use a development kit based on the ENC28J60 controller chip, the Olimex ENC28J60-H using the SPI bus to communicate with the Econotag platform.
This document does not describe how to set up a cross-compilation environment for mc1322x, for a good starter check libmc1322x
Note that we do not use the interrupt pin (INT) as the 6LBR driver is using polling instead. The reset pin (RST) is grounded as the driver is using soft reset only. The wake-on-lan (WOL) is not used.
- Obtain the latest version of 6LBR:
git clone https://github.com/cetic/6lbr cd 6lbr/examples/6lbr
- In 6lbr source directory, do the following commands :
make all_econotag make tools
Binaries for all the three modes are created in bin_econotag/
Use the mc1322x-load(.pl) program to load the 6LBR on the Econotag
mc1322x-load.pl -t /dev/ttyUSB1 -f bin_econotag/cetic_6lbr_smart_bridge
Note that you have to upload the 6LBR again when the Econotag is reset/restarted
You can program the Econotag NVM with the flasher tool provided with libmc322x :
mc1322x-load.pl -t /dev/ttyUSB1 -f flasher_econotag.bin -s bin_econotag/cetic_6lbr_smart_bridge
Due to the limited size of the Econotag RAM, it is not possible to update configuration parameters of the 6LBR directly. In order to modify these configuration parameters, one has to create a NVM configuration file using NVM Tool and flash the Econotag NVM with it.
A flashing script is available to help flashing the configuration parameters into the NVM without erasing the whole NVM.
tools/econotag/flasher.sh <nvm conf file> <device> [<additional parameters>]
For example, il you want to use the channel 24, with "cccc::" as WSN prefix, you will do :
nvm_tool --new --channel 24 --wsn-net-prefix 'cccc::' nvm.dat flasher.sh nvm.dat /dev/ttyUSB1
Your parameters should be now present in the NVM and will be used at 6LBR restart. This tool does not erase the whole NVM nor does it alter the boot flag, so you do not need to flash again the 6LBR binary.
The 6lbr_nvm_flasher binary can be rebuilt using the following command in 6lbr/tools/econotag :
make MC1322X=<path to your copy of libmc1322x> BOARD=redbee-econotag