Twingo III EasyLink Rear Camera Issues

[sasio141]

Hi.
I add EasyLink to my 2017 Twingo III PH1 based on Visteon.

I add radio from Clio V, multimedia gate/screen/cover/button from Twingo III and made auto configuration.

I have issue with rear camera : when I turn reverse gear and car not move is everything okay, but when I start reversing the car, view from camera turn off (black screen), and correct working goes on after stop a car.

Maybe is some parameter to change in DDt4All to change ? In my Clio IV for example when I start reversing faster than 10km/h visualisation of parking sensor (HMI) turn off..

ScreenRecording_10-27-2024_09-38-57_1.mp4

Any ideas?

[AndyIreland]

have you checked in this area of restrictions to see if make a difference?:

[sasio141]

I must check.
We add Clio V radio to Twingo III cause are wireless CarPlay. Albo add navigation and after update software navigation not working (nothing do after try open Navigation button).

Restriction video i Think is removed cause my friend told me about that.

In this 3 position, absent is correct value or not?

[AndyIreland]

yes i think absent is correct value to unlock. because if 'present' that would mean restriction is present

[sasio141]

Problem is only when can move back. When I turn on reverse gear and not move is okay, but when I reversing faster than 0 km/h is black screen :(

[maldenis]

Hello! Did you manage to solve your problem somehow? I also want to install additional all-round view cameras (MVC) that were installed from the factory. There is a problem with changing the Easylink parameters in the Camera config tab (ddt4all). The new values are not saved.

[sasio141]

Hi, problem is with unlock gateway in your car. Any changed must be after unlock the gateway.Wysłane z iPhone'aWiadomość napisana przez maldenis ***@***.***> w dniu 6 gru 2024, o godz. 12:53: Hello! Did you manage to solve your problem somehow? I also want to install additional all-round view cameras (MVC) that were installed from the factory. There is a problem with changing the Easylink parameters in the Camera config tab (ddt4all). The new values are not saved. —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you authored the thread.Message ID: ***@***.***>

[maldenis]

I connected the CAN bus directly to Easylink (bypassing the gateway), but still there is no change in these settings.

[AndyIreland]

I connected the CAN bus directly to Easylink (bypassing the gateway), but still there is no change in these settings.

on twingo 3 it says the touchscreen is mfd , not easylink.
anyway, did you make sure to press this button after changes?

[sasio141]

Hi in my twingo is easy link from clio V. Any changes i confirm by button Key off on left top site. At monday i will check this parameters for youWysłane z iPhone'aWiadomość napisana przez Andy Robus ***@***.***> w dniu 7 gru 2024, o godz. 16:31: I connected the CAN bus directly to Easylink (bypassing the gateway), but still there is no change in these settings. on twingo 3 it says the touchscreen is mfd , not easylink. anyway, did you make sure to press this button after changes? image.png (view on web) —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you authored the thread.Message ID: ***@***.***>