[HW Accel Support]: wyse 5070 j5005 lxc proxmox tteck high CPU usage #13631
Replies: 2 comments 7 replies
-
|
Config for C800 on Wyse 5070: |
Beta Was this translation helpful? Give feedback.
-
|
I just copy/past your config witch my credits:
|
Beta Was this translation helpful? Give feedback.
-
|
That's your error: No device available for decoder: device type vaapi needed for codec hevc. |
Beta Was this translation helpful? Give feedback.
-
|
t does indeed differ, especially 'lxc.mount.entry: /dev/dri/renderD128 dev/dri/renderD128 none bind,optional,create=file'. I need to look for passthrough for LXC. |
Beta Was this translation helpful? Give feedback.
-
|
Tteck's script should create that by itself, weird that it didn't in your case, but yeah renderD128 is your GPU and you have to have that in this file. Then on frigate lxc check if you have it in /dev/dri and also in lspci |
Beta Was this translation helpful? Give feedback.
-
|
my bad... this is lxc conf with full data proxmox dmseg apt update and apt upgrade in lxc lspci in lxc |
Beta Was this translation helpful? Give feedback.
-
|
Okay, I have moved back from LXC to the Home Assistant addon. At the end of the frigate.yaml file, I added: Frigate seems to start up correctly. I'm using OpenVINO, GPU usage is around 7%, CPU is still 60-80%, but there are fewer errors. It seems that HW acceleration is working.
still i have errors but is better than earlier. go2rtc |
Beta Was this translation helpful? Give feedback.
-
Describe the problem you are having
Hello,
I switched from the HAOS add-on due to high CPU usage and frequent crashes.
Eventually, I did a clean installation of Proxmox, using the tteck script in PVE. It worked almost without errors (three packages failed to update: "libegl-mesa0 libgbm1 libglapi-mesa"). I prepared a basic configuration for the camera, which I am including below. The camera is a Chinese model with ONVIF support. The go2rtc add-on is also installed, and my camera appears in the tests, but I haven't modified the go2rtc configuration file. Below, I will try to provide as much information as possible. When I disable hardware acceleration, the camera works, but CPU usage keeps increasing over time. I also have an ANNKE C800 and I'm experiencing the same issue with it. I added the following command to /etc/systemd/system# nano frigate.service:
environment:
LIBVA_DRIVER_NAME: i965
However, this didn't change anything.
Version
0.14.1
In which browser(s) are you experiencing the issue with?
Wersja 128.0.6613.120 (Oficjalna wersja) (64-bitowa)
Frigate config file
docker-compose file or Docker CLI command
Relevant Frigate log output
Relevant go2rtc log output
FFprobe output from your camera
Operating system
Debian
Install method
Docker Compose
Network connection
Wired
Camera make and model
VIKYLIN PG2046IRCS-P
Screenshots of the Frigate UI's System metrics pages
Any other information that may be helpful
No response
Beta Was this translation helpful? Give feedback.
All reactions