Differences between factory and "plain" bin

[dat-master]

This is a great tool, must be the fastest and easiest way to produce Tasmota firmware.
I did a couple of builds and noticed that only the firmware.factory.bin works, the "plain" firmware.bin does not.
I use the same command line to burn both bins e.g.
esptool.py -p /dev/ttyUSB0 -b 460800 write_flash 0x00000 ~/downloads/firmware.bin
Do I need to change the address or use some other parameter for firmware.bin to work?
What are the differences between them?
I am programming a module with an ESP32-D0WDQ6 (revision 1) chip with binaries produced by https://gitpod.io/#https://github.com/benzino77/tasmocompiler
Thanks

[benzino77]

Hi,

Have a look at discord channel, there was couple of questions regarding those binaries. Plain binary has to be flashed with partitions , bootloaders and boot_app0 files (three additional files needed), using factory binary you only need this one.
This is only my understanding, for more information you should go to Tasmota Discord Channel and ask Tasmota Dev Team.

[dat-master]

Thanks for the prompt reply.
I suspected something like that.
Didn't know about the discord channel, I will go there too.