Skip to content

Latest commit

 

History

History
63 lines (46 loc) · 1.59 KB

rootShell.md

File metadata and controls

63 lines (46 loc) · 1.59 KB

How to get root CLI & root Shell

LTF-726x-BH+

Connect via SSH or UART to obtain root shell.

XG-99S, XG-99M

After logging in via telnet or UART, you will first get the CLI with user privileges.

ONT>

The root CLI can be obtained by executing the enable command on this CLI.

ONT> enable
#ONT>

can switch to the root shell by executing the following command.

#ONT> system/shell
#ONT/System/Shell> sh
#

There are several other commands in the root CLI. The following is a list of typical commands,

  • /traffic/pon/show onu Obtain ont’s authentication status, SN, LOID password, PLOAM password, etc.
  • /system/misc Change the SN, vendor, PLOAM password, and other settings stored in its custom ROM (mtd9, mtd10)
  • /system/mib/show "MIB No." Get MIB values. example, #ONT> /system/mib/show 256 /system/mib/show ? command can get a list of supported MIBs.

XE-99S

Connect via SSH or UART to obtain root shell. can switch to the CIG CLI by executing the following command.

XE-99S # cig-cli
ONT>

Nokia XS-010X-Q

Connect via Telnet, SSH or UART to obtain root shell.

Some new devices may not allow access shell via UART.
Use programmer to extract the firmware, then modify it using tools like WinHex.
(Tested on 2023 manufactured Nokia XS-010X-Q from eBay)

  1. Open WinHex, press ALT+G and go to offset 3500000.
  2. Select range 3500000 to 3b00000, replace with
    /mtd/NOKIA_XS-010X-Q/patch/kernel0.bin, and save the file.
  3. Use programmer to write the modified firmware back to flash memory.