Replies: 3 comments 3 replies
-
I'm planning on updating the configuration page of the wiki to better go over some of the options. I had figured most people would start with the ManualMesh template, hence why there wasn't a ton of info on the setting required. If you're interested why it uses bilinear, its because bilinear provides a marginally more robust system for creating the mesh as well as simplifying some of the code. |
Beta Was this translation helpful? Give feedback.
-
I used the 3x3 mesh firmware and its wonderful, need to fine tune it a bit more but overall it works great. I updated my slicer to add M420 S1 Great work. |
Beta Was this translation helpful? Give feedback.
-
@Jyers I have a question about how to see that the mesh is loaded/used. I have been looking at Z axis rod but I cannot see or feel it move though the mesh values varies across the bed. |
Beta Was this translation helpful? Give feedback.
-
Hey there,
I had to play around with configuration options quite a bit, to get manual mesh leveling running.
So I just want to share this here for others who were following some tutorials on it and don't get it to work with this firmware (that is really awesome btw!)
Instead of define MESH_BED_LEVELING, you need to define AUTO_BED_LEVELING_BILINEAR for the manual(!) mesh to work.
This should either be documented or fixed/changed.
Beta Was this translation helpful? Give feedback.
All reactions