-
|
When I choose warmup from the preheat menu, warms up fine, it runs indefinitely. When I choose, PLA, it heats up fine then shuts down after approx 5 minutes. Is this by design? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
|
From what I can tell nothing in the firmware would be doing this. It could be some safety feature I'm unaware of that is only triggered at certain temps, but I find that unlikely. |
Beta Was this translation helpful? Give feedback.
-
|
I pre heated w/o octoprint connected since I had a previous heater timeout plugin but it still times out after a few mins. So no one else has this issue? |
Beta Was this translation helpful? Give feedback.
From what I can tell nothing in the firmware would be doing this. It could be some safety feature I'm unaware of that is only triggered at certain temps, but I find that unlikely.