-
so just installed BLtouch and gone for the 4.2.2 10x10 HS. i have complete a mesh ok and saved it, i have set the the z offset ok. set the x and y probe offset. Every time I go to printer its zero's x/y fine, moves to the center and probes the bed twice and the probe then stays retracted and solid red. it moves back up 10mm and then displays STOPPED on the screen. From Octoprint terminal it says stopped due to error. Any ideas what i am doing wrong. been using your firmware on manual mesh no problems. BTW thank you for the excellent versions |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 2 replies
-
also when doing the 100 mesh i'm sure it stopped after point 91 |
Beta Was this translation helpful? Give feedback.
also when doing the 100 mesh i'm sure it stopped after point 91