How do I measure for direct drive? #327
Answered
by
Jyers
kyzitemelos
asked this question in
Q&A
-
I have a micro swiss direct drive and hotend but am unable to measure for it and have followed Micro Swiss's vague instructions but UBL is still not lining up. |
Beta Was this translation helpful? Give feedback.
Answered by
Jyers
Mar 26, 2021
Replies: 1 comment
-
The best method I have found to measure nozzle to probe offsets is to move the nozzle to any point from the move menu. Mark that point on the bed, then move the printhead until the probe is directly over that point. The differences between these two positions are your offsets |
Beta Was this translation helpful? Give feedback.
0 replies
Answer selected by
Jyers
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
The best method I have found to measure nozzle to probe offsets is to move the nozzle to any point from the move menu. Mark that point on the bed, then move the printhead until the probe is directly over that point. The differences between these two positions are your offsets