X axis goes too far when leveling, hits my cable chain #1883
-
|
I have a cable chain mount on the hot end that hits the side when the hotend moves to the right while leveling (while it's trying to get the probe to the very right side of the bed). How can I fix it so it doesn't try to move so far to the right? This is on an Ender 3 V2 with CR touch, 15x15 HS UBL firmware. |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 4 replies
-
|
Had similar issues few months ago. You need to change X_Max_POS value in firmware then compile it. Check this thread of some details. If you have not compiled firmware before, here are some instructions in this post. |
Beta Was this translation helpful? Give feedback.
-
|
Thanks so much for the quick reply! |
Beta Was this translation helpful? Give feedback.
-
|
most welcome. Hope it gets fixed. |
Beta Was this translation helpful? Give feedback.
-
|
Sorry I thought I had this figured out, but I'm on linux and trying to compile this after editing. Do you have any advice on how to do that? |
Beta Was this translation helpful? Give feedback.
-
|
Great hope it worked for you. |
Beta Was this translation helpful? Give feedback.
@TekoXVI
Had similar issues few months ago. You need to change X_Max_POS value in firmware then compile it. Check this thread of some details.
If you have not compiled firmware before, here are some instructions in this post.