-
Notifications
You must be signed in to change notification settings - Fork 0
/
gene_count_iTOL_header.txt
63 lines (47 loc) · 2.85 KB
/
gene_count_iTOL_header.txt
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
DATASET_SIMPLEBAR
#In simple bar charts, each ID is associated to a single numeric value which is displayed as a bar outside the tree.
#lines starting with a hash are comments and ignored during parsing
#=================================================================#
# MANDATORY SETTINGS #
#=================================================================#
#select the separator which is used to delimit the data below (TAB,SPACE or COMMA).This separator must be used throughout this file.
SEPARATOR TAB
#SEPARATOR SPACE
#SEPARATOR COMMA
#label is used in the legend table (can be changed later)
DATASET_LABEL GENENAME
#dataset color (can be changed later)
COLOR #000000
#=================================================================#
# OPTIONAL SETTINGS #
#=================================================================#
#=================================================================#
# all other optional settings can be set or changed later #
# in the web interface (under 'Datasets' tab) #
#=================================================================#
#dataset scale: you can simply set the values where the scale will be drawn
#maximum width
#WIDTH,1000
#left margin, used to increase/decrease the spacing to the next dataset. Can be negative, causing datasets to overlap.
#MARGIN,0
#always show internal values; if set, values associated to internal nodes will be displayed even if these nodes are not collapsed. It could cause overlapping in the dataset display.
#SHOW_INTERNAL,0
#show dashed lines between leaf labels and the dataset
#DASHED_LINES,1
#bar height factor; Default bar height will be slightly less than the available space between leaves, but you can set a multiplication factor here to increase/decrease it (values from 0 to 1 will decrease it, values above 1 will increase it)
#HEIGHT_FACTOR,1
#Display individual values above the bars
#SHOW_VALUE,0
#Bars are aligned to the node lines by default. Using BAR_SHIFT, you can move them all up/down by a fixed amount
#BAR_SHIFT,0
#BAR_ZERO specifies which dataset value will be used as a starting point for drawing the bars. Dataset values smaller than BAR_ZERO will be displayed to the left (possibly overlapping the tree, unless MARGIN is increased)
#BAR_ZERO,0
#border width; if set above 0, a border of specified width (in pixels) will be drawn around the bars
#BORDER_WIDTH,0
#border color; used when BORDER_WIDTH is above 0
#BORDER_COLOR,#0000ff
#Internal tree nodes can be specified using IDs directly, or using the 'last common ancestor' method described in iTOL help pages
#=================================================================#
# Actual data follows after the "DATA" keyword #
#=================================================================#
DATA