AOFI net is missing in schematics

[think-inhell]

Hi,

after watching the PDF schematics I found out that the AOFI net is not connected to FTDI chip.
Instead the RxD Pin of the FTDI Chip is connected to GND. The PCB-File is ok.

CR-10 Schematic.pdf
meatics

[RudolphRiedel]

I does not really matter since the schematic is not for the same revision as the board file:
Creality3DPrinting/CR-10#1

The presence of the jumper J5 suggests that the schematic is for the prior version of the board.

[Spice-Weasel]

I'd like to bump this issue - thanks for uploading a schematic, but there are many elements not shown on the V1.1.2 motherboard.

[RudolphRiedel]

Passed time proved somewhat that they do not care.
And neither does anyone at OSHWA.

I did though: https://github.com/RudolphRiedel/CR10-Melzi-1.1.2

[Spice-Weasel]

Passed time proved somewhat that they do not care.
And neither does anyone at OSHWA.

I did though: https://github.com/RudolphRiedel/CR10-Melzi-1.1.2

This is brilliant, thank you - this is what I was looking for, thank you for putting the time in. I'll post this on Reddit crediting you if you're ok with that.

[RudolphRrr]

It's public, just post the link as you wish, no need to give credit. And I believe the link has been posted on reddit before.