Orange Pi Zero GPIO Power Printer Relay Issue

[CNCmarlin]

Hello,

I am not super smart when in comes to programming, but can usually find the resources I need to fix an issue when one arrives. I would greatly appreciate your time and help.

I am trying to use an Orange Pi Zero 2, which i already have been successfully using moonraker and mainsail on for some time, to control a 3.3v relay and power on and off my printer from mainsail.

Side note I have set this up with my raspberry pi 3 and 4 very easily since they are quite mainstream thanks for the simple setup!

With my orange pi on the other hand I have not been able to get past a pin parsing issue. Any way I type the pin it continues to show this error in mainsail and in the moonraker log. I will provide any information needed that may not be included in my moonraker log file.

Thanks!
moonraker.log