diff --git a/docs/products/plt1/calibrating-plt1.md b/docs/products/plt1/calibrating-plt1.md
new file mode 100644
index 000000000..20669b39c
--- /dev/null
+++ b/docs/products/plt1/calibrating-plt1.md
@@ -0,0 +1,14 @@
+# Calibrating Soil Moisture
+
+This guide will take you through calibrating your PLT-1's moisture sensor. The sensors come with the default calibration so this method is only needed if you want to make your own adjustments.
+
+ 
+
+1. Take your PLT-1 out of the soil and clean off the probe. It is important to get the dirt off to have the best calibration.
+2. Make sure the PLT-1 probe is sitting in the air or on a dry non conductive surface and plugged in.
+3. Visit the device's entity drill down page in Home Assistant and scroll down to the diagnostics section. Enable the entity "Soil ADC"
+4. Give the sensor a minute for this new entity to populate
+5. Once the value is populated take the value and put it into the "Dry Voltage" entity
+6. Now place the prob portion of the PLT-1 into a cup of water. Be careful to not dunk the entire sensor, only the exposed PCB below "Apollo" and the horizontal line can be exposed to water
+7. Grab the "Soil ADC" value now and put the value into the "100% Water Voltage" entity
+8. You can put your PLT-1 back into your plant and you now have a calibrated
\ No newline at end of file
diff --git a/mkdocs.yml b/mkdocs.yml
index 1d8468b10..1ced9332f 100644
--- a/mkdocs.yml
+++ b/mkdocs.yml
@@ -174,6 +174,7 @@ nav:
             - Updating: products/plt1/updating.md
             - Bluetooth Proxy: products/general/setup/bluetooth-proxy-plt1.md
             - Sensor Definitons: products/plt1/sensor-definitions.md
+            - Calibrating Soil Moisture: products/plt1/calibrating-plt1.md
           - Reviews: products/plt1/reviews.md
           - Examples: 
             - Flower Card: products/plt1/examples/flower-card.md